CDL · Vehicle inspection
When you stop for an inspection partway through a trip, what should you check?
Correct answer: All of these are correct.
Answer options
- ASigns that the tires or brakes are overheating
- BWhether the cargo is still properly secured
- CAll of these are correct Correct
Why
Stops during a trip are the time to confirm that the load and its tie-downs have not shifted or loosened and to check whether any tires or brakes are running too hot. Both checks belong in a proper en route inspection.
About this question
Topic: Vehicle inspection License: CDL
Part of these practice sets:
Where it applies: Asked in every state.
Practice the whole set
This question is part of Loading and Securing Cargo (21 questions). Take the full set and check your score.
Practice Loading and Securing CargoMore questions from Loading and Securing Cargo
- What can happen if most of a vehicle's load is placed over the steering axle?
- What is likely to happen if most of the cargo is loaded against one side of a trailer?
- Which of these is NOT negatively affected when a vehicle carries too much cargo?
- If the front axle carries too little weight, what can happen?
- One basic rule of loading is that the cargo should be:
- Cargo has been loaded so the drive axle carries only a small share of the weight. What problem may this cause?
- At a minimum, how many tie-downs should be used on cargo that is able to shift?
- Under the general rule for securing cargo, you need a minimum of one tie-down for each:
Practice on your phone.
Practice here in your browser, or use the app with the same questions and explanations. It's free on the App Store.