CDL · Cargo
Cargo has been loaded so the drive axle carries only a small share of the weight. What problem may this cause?
Correct answer: Poor grip from the drive wheels.
Answer options
- APoor grip from the drive wheels Correct
- BSteadier, more responsive handling
- COverloading of the drive axle tires
Why
Drive wheels need enough weight pressing them onto the road to grip; with too little, they can spin or slide, especially on wet, snowy, or icy pavement. Arrange the load so each axle carries its proper share.
About this question
Topic: Cargo License: CDL
Part of these practice sets:
Where it applies: Asked in every state.
Practice the whole set
This question is part of Loading and Securing Cargo (21 questions). Take the full set and check your score.
Practice Loading and Securing CargoMore questions from Loading and Securing Cargo
- If the front axle carries too little weight, what can happen?
- Under the general rule for securing cargo, you need a minimum of one tie-down for each:
- What is likely to happen if most of the cargo is loaded against one side of a trailer?
- How does a bridge formula treat the maximum weight allowed on axles?
- When you stop for an inspection partway through a trip, what should you check?
- What is the job of tie-downs like the straps holding the load in this picture?
- What can happen if most of a vehicle's load is placed over the steering axle?
- What does the term tire load refer to?
Practice on your phone.
Practice here in your browser, or use the app with the same questions and explanations. It's free on the App Store.